Published 2 November 2026 · 4 minute read
The short answer
Metal cladding fades and turns chalky because sunlight slowly breaks down the factory coating, starting on the walls that face south and west. Washing removes the loose chalk and dirt, and on lightly weathered cladding that may be enough. Once the pigment itself has gone, a respray in the original or a new colour brings it back.
What fading and chalking are
Most industrial units are clad in steel or aluminium sheets with a factory coating, usually plastisol or PVF2. That coating holds the colour and protects the metal. Over the years sunlight breaks down the resin that binds the coating together, the pigment loosens and the surface turns to a fine powder. That powder is what people mean by chalking. The colour drops at the same time, so a dark green wall turns a dusty grey green and a red goes towards pink.
Summer is when it shows most. Long bright days put more sun on the walls, and a dry spell leaves the chalk sitting on the surface where you can see it and wipe it off. At this stage the sheets underneath are usually still sound. The wear is in the top layer of the coating.
Why one side of the building looks worse
The walls facing south and west take the most sun, and on most sites they also take the worst of the weather. Those elevations fade first and fade furthest. The north side, and any wall shaded by a neighbouring building, often keeps its colour for years longer. Shaded walls are more likely to grow green algae.
So a unit can look patchy, with one elevation several shades paler than the next. Sheltered spots show you the colour the building started with: behind a downpipe or under a canopy.
Checking your own cladding
Pick a dry day and start with the sunniest wall.
- Rub a clean, dry hand on the sheet. Coloured powder on your palm means the coating is chalking
- Compare the colour with a sheltered spot on the same wall. A clear difference means the pigment has faded
- Look along the sheet laps and bottom edges for brown staining or bubbling paint, which is usually cut edge corrosion
- Look at the shutters, doors and flashings too, because they fade alongside the cladding
Our yearly cladding and roof check has the full list, with a key to what each sign usually means.
What a clean will do
A low pressure clean with a solution suited to the coating takes off the loose chalk and the dirt. On lightly weathered cladding the colour comes back close to the original, and the clean also shows the real condition of the sheets underneath. Our cladding cleaning guide explains how it is done without harming the factory finish.
Scrubbing hard, or using a high pressure lance close to a chalky surface, strips away more of a coating that is already weak. And a clean cannot put pigment back into a coating that has lost it. If the wall still looks pale and powdery once it is washed and dry, cleaning has done all it can.
When a respray is the answer
Once the coating has chalked through and the colour has gone, a respray brings back the colour and the protection together. The cladding is cleaned, any corrosion is treated, a primer matched to the existing coating goes on, and a topcoat is sprayed in the original colour or a new one from any RAL or BS reference. Most commercial jobs take three to seven days on site, and cladding coating systems typically carry a ten year manufacturer warranty.
You may not need to do the whole building. The elevations that face the sun often need a respray while the sheltered sides only need a clean, and the survey tells you which is which. Our cladding spraying explained guide covers each stage of the job.
Leaving it for another year
Chalking on its own starts as a cosmetic problem. Over time the thinner coating gives the metal less protection, and the cut edges and fixings are the first places to rust. Cladding that is faded and chalky but still free of rust is in the best state to respray, because the preparation is mostly cleaning. Once corrosion has started at the laps it has to be treated first, which adds time and cost to the job.
Spring to autumn is the main spraying season, so if a wall has faded badly enough to bother you this summer, book the survey early.





